I also need more clones of Mint and Genovese Basil. There was another tiny plastic box lying around that I use to bottom water some small pots. I decided, I'll give it a try despite it holding only a little under 2 liters of water. So I did three sites with Mint and the other 3 sites with Genovese Basil. The mint cuttings had super tiny leaves so I decided to overpopulate each site with 7 cuttings each but did still just 3 cuttings on the basil. I only placed humidity domes on the mint since the basil seemed to be holding up quite well.
Wednesday, November 11, 2015
Bubbler Cloner on Smaller Container
I've decided to try some drastic changes on my bubbler cloner. First mod - smaller container. My original container was a 12L plastic box. This one holds only about 3 liters of water and is roughly only 10 cm deep. Second mod - new air pump. I'm also trying a more silent air pump (though it seems to have much less volume output than the original pump I used). Third mod/change - more than one cutting per site. Here it is populated on all 6 sites with 3 fresh cuttings of Thai Basil each site. I did put plastic cups on each site as humidity domes - the cuttings seemed to be wilting quite quickly.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment